• Hot-pluggable SFP+ footprint
• Supports rate selectable 1.25 Gb/sOr 9.95 to 10.3 Gb/s bit rates
• Power dissipation < 1W
• RoHS-6 compliant ( lead-free )
• Single 3.3V power supply
• Maximum link length of 300m on2000 MHZ-km MMF
• Uncooled 850nm VCSEL laser
• Receiver limiting electrical interface
• Duplex LC Connector
• Built-in digital diagnostic functions
• Commercial temperature range£º 0¡ãC to 70¡ãC(Standard), -40¡ãC to 85¡ãC (Industrial)

1. Compliant with SFF-8431 and IEE802.3ae
2. Data rate selectable ¡Ü4.25Gbps or 9.95Gbps to 10.3Gbps bit rates
3. Cooled EML transmitter and PIN receiver
4. link length up to 40km
5. Low Power Dissipation 1.5W Maximum
6. Operating Case Temperature£º0¡ãC to 70¡ãC(Standard), -40¡ãC to 85¡ãC (Industrial)
7. Single 3.3V power supply
8. Diagnostic Performance Monitoring of module temperature, supplyVoltages, laser bias current, transmit optical power, receive optical power
9. RoHS compliant and lead free

1. Compliant with SFF-8431 and IEE802.3ae
2. Data rate selectable ¡Ü4.25Gbps or 9.95Gbps to 11.3Gbps bit rates
3. Cooled EML transmitter and APD receiver
4. link length up to 80km
5. Low Power Dissipation 1.4W Typical (Maximum:2W)
6. Operating Case Temperature:0¡ãC to 70¡ãC(Standard), -40¡ãC to 85¡ãC (Industrial)
7. Single 3.3V power supply
8. Diagnostic Performance Monitoring of module temperature, supplyVoltages, laser bias current, transmit optical power, receive optical power
9. RoHS compliant and lead free

SGMII SFP is designed for 100BASE-FX applications, with build-in PHY device supporting SGMII interface. The standard serial ID information Compatible with SFP MSA describes the transceiver¡¯s capabilities, standard interfaces, manufacturer and other information. The host equipment can access this information via the 2-wire serial CMOS EEPROM protocol. For further information, please refer to SFP Multi-Source Agreement (MSA). SGMI SFP transceivers are 100BASE-FX Small Form-Factor Pluggable (SFP) Fast Ethernet Interface Converter on Gigabit SFP Ports.

1.  Connection Gigabit Ethernet To Fast Ethernet
2.  Switch to Switch interface
3.  Switched backplane applications
4.  Router/Server interface

F-tone SGMII-SFP-2km is designed for 100BASE-FX applications, supporting distance from 0.5m to 2km on MMF with build-in PHY device supporting SGMII interface.
The optical output can be disabled by a TTL logic high-level input of Tx Disable. Tx Fault is provided to indicate that degradation of the laser.